| |
Box Contents :
- 1 x Reservoir
- (2) 3/8" barbs, (2) 1/2" barbs
- (1) fill-port plug
- Mounting screws
- Bracket set including (1) "L" and (2) "U's"
- (2) Velcro pads
Warning
Do not clean with alcohol
more reservoirs, click and go.
single bay reservoir
dual bay reservoirs
reservoir for laning ddc
passive aluminium reservoir
high flow reservoir
cooling water, water cooling pc, water cooling cpu, computer water cooling, computer water cooling parts, cost of cooling water,
|
Review of this reservoir from users
Good Res. I Reccomend
05-12-2008
Reviewer: Sino (1)
all products have flaws, but be glad this one only has 2 minor ones, nothing big enough to warrant a lower rating. just take my advice and put some waterproofing tape on the fittings because mine had a very slight leak. also, as others have mentioned the cap strips and that sucks, but if you need to refill it more than 5 times, you have a bigger problem than the cap
Works great, but...
01-01-2008
Reviewer: starkat (3)
This is one versatile reservoir. Comes with mounting brackets not shown in the images here, which makes for a variety of mounting options. It''s even small enough that if you need more space later on, you could get a second one of these and include it in the cooling loop. However, there''s a couple of small flaws: -fillport is a non-standard "pg7" thread type, which is proprietary enough that there''s no hose barbs made in this thread type.. This means that if you''re hoping to plug a barb into the top of the res. and connect it to a case-mounted fill port, you''ll need to re-tap the top hole to match, which is no easy task on acrylic. I chose instead to ''thread'' the end of a hard nylon hose to pg7 type and screwed it in to the top hole, then sealed it with a small bead of silicone. -Secondly, the included steel mounting brackets, while awesome, include 1.75" long screws, which are a bit short for their setup, and while the instructions indicate to ''push'' the nut on, that risks damaging the reservoir welds. You''ll need to get some longer screws (and cut them down if necessary), or some non-locking 6-32 nuts. Other than those two minor flaws, this reservoir is excellent, and performs flawlessly. If you''re engineering-minded and don''t mind doing a little hardware hacking, this is the reservoir for you.
Good res
11-10-2007
Reviewer: Franzkefka (13)
no real complaints with this one its just a nice straight forward resivior and worth the small price too, cant beat it. have it in a loop with the Swiftech 650 pump 1/2" ID tubing inlet to the pump on the bottom fitting and 3/8" ID on the next opening up for the return line.
Perfect
10-16-2007
Reviewer: Dude (2)
Its small, leak proof, 3/8 and 1/2 has a fill port... what more do you need. It comes with plenty brackets for different mounting options. I would recommend to aanyone
I also liked this rez
09-12-2007
Reviewer: Procupine14 (4)
Its a good buy if you don''t have enough room for a full drive bay reservoir or you just happen to have a relatively small case. I have the same problem with the cap stripping on me. It hasn''t gone completely yet but its pretty close. Thats why I can only give this product a 4
|
